U.S. Ground
Parcel Shipments
See Shipping Policy

Phoenix Contact Wire Duct

Phoenix Contact wire duct is an essential component for cable management, particularly designed for installation in control cabinets. These cable ducts, usually in gray, are composed of an upper part and a mounting base, facilitating a streamlined installation process. The design of the Phoenix Contact wire duct is such that it allows for easy and secure placement of installed conductors within control cabinets, ensuring that cables are not only neatly organized but also securely held.

One notable feature of the Phoenix Contact wire duct system is the use of wire retaining clips and cable duct bars, which enhance the stability and organization of cables within the duct. These additions are particularly useful in environments where cable integrity and management are critical, such as in industrial control cabinets. The ducts are available in various sizes, with some models having a length of 2000 mm, catering to different installation needs.

 

Products

Products Per Page: Sort By:
$42.77
Cover, for the contact- and dust-protected encapsulation of the components
$1.16
Cover profile, for single-bolt terminal block M8, length: 75 mm, width: 21 mm, height: 6.5 mm, color: gray
$6.16
Adjustable cover holder, for mounting covers (up to 3 mm thick) on terminal blocks, can be used for CLIPFIX 35 and E/UK
$2.04
Cover, width: 5 mm, height: 17.5 mm, material: ABS, length: 50 mm, color: transparent
$49.37
Flat-ribbon cover, for covering terminal strips, 2 mm thick, 10 cm wide, an additional requirement are 2 E/UK end brackets and 2 adjustable VAH cover holders. The max. supply length is 100 cm
$1.44
Cover, width: 7 mm, height: 23.8 mm, material: ABS, length: 52 mm, color: transparent
$4.37
Cover profile holder, 10 mm wide, for mounting on NS 32 or NS 35/7.5, for fixing the holding profile APK-HP, labeling with Zack strip ZB 10
$57.33
Cover profile, for covering terminal strips, snapped onto APT-ME cover profile carrier or APH-ME end bracket. A cover profile carrier should be positioned at the ends and at intervals of around 40 cm. Length supplied: 1 m
$47.18
Flat-ribbon cover, for covering terminal strips, 2 mm thick, 9 cm wide, an additional requirement are 2 E/UK end brackets and 2 adjustable VAH cover holders. The max. supply length is 100 cm
$18.30
Holding profile, snaps into the cover holder APK-TU, with groove for Zack strip ZB 5 to ZB 10, length: 2 m
$2.81
Cover profile, for single-bolt terminal block M10, length: 156 mm, width: 32 mm, height: 6.5 mm, color: gray
$1.59
Single cover, for covering one terminal block, snap fit, cannot be labeled, color: transparent